Current Cathodic Protection of Internal Submerged
Surfaces of Steel Water Tanks", and RP0-196,
"Galvanic Anode Cathodic Protection of Internal
Submerged Surfaces of Steel Water Tanks."
**************************************************************************
**************************************************************************
NOTE: The following information should be shown on
the drawings:
1. Dimensions of tank, including riser (if tank is
elevated), structural supports and overflow.
2. Locations of all anodes, reference electrodes,
junction boxes, test boxes, rectifiers, power
connections, wire and conduit.
3.
Installation details for anodes and rectifiers.
4. Electrical single-line diagrams, elevations,
limiting dimensions, and equipment ratings which are
not covered in the specification.
5. Remote indicating or control requirements.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C119.1
(2002) Sealed Insulated Underground
Connector Systems Rated 600 Volts
ASTM INTERNATIONAL (ASTM)
ASTM A 518
(1992) Corrosion-Resistant High-Silicon
Iron Castings
ASTM A 518M
(1992; R 1997) Corrosion-Resistant
High-Silicon Iron Castings (Metric)
ASTM B 3
(2001) Soft or Annealed Copper Wire
ASTM B 8
(2004) Concentric-Lay-Stranded Copper
SECTION 13112N
Page 4