District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-02 Shop Drawings
Insulating flange sets
Anode junction boxes, bonding boxes and test stations
Joint bonds
SD-03 Product Data
Anodes; G
Anode junction boxes, bonding boxes, and test stations
Insulating flange sets
Dielectric unions
Wires
Cable and wire
Casings, insulation, and seals
Shunt resistors
Permanent reference electrodes; G
SD-07 Certificates
Qualifications of Corrosion Engineer; G
SD-10 Operation and Maintenance Data
Cathodic Protection System, Data Package 5; G
Submit in accordance with Section 01781 OPERATION AND
MAINTENANCE DATA.
SD-11, Closeout Submittals
SECTION 13110N
Page 7
Previous Page
