fastenings for doors and drawers with particle board cores shall be of the
through-bolt type. The types and finishes of hardware shall be as follows:
BHMA DESIGNATION
TYPE
NUMBER
FINISH
[_____]
[_____]
[_____]
2.6
COLOR, TEXTURE, AND PATTERN
**************************************************************************
NOTE: Editing of color reference sentence(s) shall
be coordinated with the Government. Generally, UFGS
09915 COLOR SCHEDULE or drawing is used when the
project is designed by an Architect or Interior
designer. Color shall be selected from
manufacturers standard colors or identified as a
manufacturers color in this specification only when
the project is very simple and has minimal finishes.
When the Government directs that color be located in
the drawings a note shall be added that states:
"Where color is shown as being specific to one
manufacturer, an equivalent color by another
manufacturer may be submitted for approval.
Manufacturers and materials specified are not
intended to limit the selection of equal colors from
other manufacturers. The word "color" as used
herein includes surface color and pattern."
Prior to specifying a custom color finish, research
to determine if additional cost and lead time is
feasible. Note there is often a minimum order
requirement; this requirement will also affect
future orders.
When a manufacturer's name, stock number, pattern,
and color is used, be certain that the product
conforms to this specification, as edited.
**************************************************************************
Color shall be [in accordance with Section 09915 COLOR SCHEDULE.] [as
indicated on the drawings.] [selected from manufacturers standard colors.]
[[______.] Color listed is not intended to limit the selection of equal
colors from other manufacturers.]
PART 3
EXECUTION
3.1
INSTALLATION
Cabinets shall be installed level, plumb, and true to line, and shall be
attached to the walls or floors with suitable devices to securely anchor
each unit. Countertops, accessories, and hardware shall be installed as
indicated on the drawings. Installation shall be in accordance with the
manufacturer's approved printed instructions. The inner edge of sink
cut-outs in laminated plastic tops shall be painted with a coat of
semigloss enamel paint and sink flanges shall be set in a bed of sealant.
Closer and filler strips and finish moldings shall be provided as required.
SECTION 12320A
Page 9
Previous Page
