3.2.2
Site Visits
Manufacturer's representative shall assist in the proper installation and
checking of the equipment for a period of time necessary to insure a
completed installation. The representative shall, for a period not less
than three full days, start up the equipment, supervise initial operations,
perform the required field tests and instruct plant operators in the proper
care, operation and maintenance of the equipment. Upon request of the
Government, at any time during the 1-year warranty period, the
representative shall recheck the system, recalibrate and adjust equipment,
answer plant operator's questions and review operation and maintenance
procedures.
3.2.3
Field Training
3.2.3.1
General Requirements
Instruction shall be a combination of classroom and hands-on training at
the site. Representative shall instruct designated maintenance and
operations personnel in the recommended corrective and preventive
maintenance procedures for the equipment. Field training shall cover each
3.2.3.2
Instruction Lesson Plan
A lesson plan shall be prepared which shall include the elements presented
in the outline specified below. Specific components and procedures shall
be identified in the proposed lesson plan. Specific instruction topics
shall be detailed. Training aids to be utilized in the instruction shall
be referenced and attached where applicable to the proposed lesson plan.
Hands-on demonstrations planned for the instruction and estimated duration
of each segment of the training shall be described in the lesson plan.
3.2.3.3
Training Outline
The elements presented in the following outline shall be included in the
instruction as a minimum:
a.
Equipment operation.
b.
c.
Equipment preventative maintenance.
d.
Equipment troubleshooting.
e.
f.
Hands-on demonstrations.
3.3
ADJUSTING AND CLEANING
Equipment shall be tested, calibrated, adjusted and operated to verify its
satisfactory operation. Equipment shall be cleaned of dirt, dust and
foreign matter.
3.4
TESTING
3.4.1
Field Testing
After Contractor and Contracting Officer have mutually agreed that the
equipment installation is complete and ready for continuous operation,
Contractor shall conduct an operating test of the equipment and controls in
the presence of the Contracting Officer to demonstrate satisfactory
SECTION 11376
Page 20