2.4
CLEANING SYSTEM
2.4.1
General
system shall [be a permanent in-channel installation] [an out-of-channel
installation] [a portable cleaning installation with basin] for cleaning
individual lamp sleeves or entire lamp modules.
2.4.2
Cleaning Tank
Portable cleaning tank shall be stainless steel and equipped with air
blower (compressor), lamp module rack, hose connections and drains. Tank
shall hold at least [3 horizontal modules] [1 vertical module] and be
equipped with hard rubber casters. Tank shall have a sealed cover to
prevent spilling. Unit shall be equipped with disconnect switch, a
grounded plug and 3 m 10 feet of outdoor cable.
2.4.3
Cleaning Rack
A cleaning rack mounted above the portable cleaning tank shall be provided
to hold one horizontal module above the cleaning liquid for hand wiping of
the sleeves.
2.4.4
Cleaning Fluid
Sleeve conditioner and cleaning solution shall be provided for 12 months of
normal operation. Conditioner and cleaning solution shall be supplied in
containers not greater than 20 L 5 gallon capacity.
2.5
PAINTING
Shop painting of ferrous metal surfaces shall be in accordance with
manufacturer's standard practices.
2.6
ANCHOR BOLTS
Stainless steel anchor bolts of the size required and with ample strength
for the purpose intended shall be provided by the Contractor. Hooked
anchor bolts shall be directly embedded during placement of concrete.
PART 3
EXECUTION
3.1
INSTALLATION
Installation shall be in accordance with the drawings, shop drawings, and
manufacturer's instructions and recommendations.
3.2
MANUFACTURER'S SERVICES
3.2.1
Manufacturer's Representative
Services of a qualified manufacturer's field service representative shall
be provided. The representative shall supervise the installation,
adjustment, testing of equipment and instruct plant operators in the care,
operation, and maintenance of the equipment.
SECTION 11376
Page 19