requirements. Pass-through drawer shall be of size indicated on the
drawings and shall be designed to prohibit forcible entry or direct aim by
the insertion of the muzzle of a firearm from exterior side when drawer is
in the open position. [Assembly shall provide a weather resistant
opening.] Attachment to wall assembly shall be in accordance with
manufacturer's recommendations. All aspects of the assembly, including
hardware and method of anchorage to wall, shall be included in the labeling
or test certification. Finish shall be [primed for painting] [satin
stainless steel].
2.11
BULLET-RESISTANT PREFABRICATED MODULAR ENCLOSURE
**************************************************************************
NOTE: Prefabricated enclosures as specified herein
are intended for use primarily as hardlines on the
interior of a facility, i.e., bullet-resistant
partitions. Develop separate specifications if
bullet resistant guards houses, control towers,
etc., are required. Coordinate this specification
with other disciplines where electrical work,
plumbing, or HVAC are required.
**************************************************************************
Enclosure shall consist of prefabricated, bullet-resistant, modular
[insulated] wall [and] [ceiling] [and floor] panels with [doors,]
[windows,] [louvers,] [gunports,] [and] all necessary connecting posts,
hardware and accessories. Complete enclosure shall be of minimum
dimensions shown on the drawings. [Doors,] [windows,] [louvers,] [and]
[gunports] shall be in accordance with the requirements specified in those
respective paragraphs. Components shall be factory-welded assemblies. All
metal components shall be factory painted with rust inhibitive primer
unless indicated otherwise. All exposed welds shall be dressed smooth.
Workmanship shall be rigid, neat in appearance, and free from defects.
[Enclosure shall be designed to be relocatable by [crane] [forklift].]
2.12
ACCESSORIES
All accessories shall be provided for the installation or erection of above
components into the surrounding structure. Anchorage shall be as strong
and bullet-resistant as the components. Installation/erection shall be per
manufacturer's recommended instructions.
2.13
LABELING
**************************************************************************
NOTE: Model numbers and rating labels advertise the
level of threat which the component is capable of
resisting. Require removable labels where possible.
Where this information cannot be removable, specify
that it shall be on the protected side or concealed
from view by casual observers.
**************************************************************************
Bullet-resistant equipment shall be plainly [and permanently] labeled in
accordance with regulatory requirements. Label shall be compatible with
plastic or coating. Label shall be visible only on protected side, after
installation and shall include the following information:
a.
Manufacturer's name or identifying symbol
SECTION 11035
Page 28
Previous Page
