with the floor surfacing material.
3.2
MIXING
Proportion and mix the floor surfacing components in accordance with the
manufacturer's instructions.
3.3
APPLICATION
Apply primer, floor surfacing, and seal coat in accordance with the
manufacturer's recommendations and the following requirements.
3.3.1
Primer
Apply primer uniformly over the entire area to receive floor surfacing
using clean rubber squeegees or clean steel trowels. Do not allow primer
to collect in depressions. Allow primer to dry thoroughly before the next
coat is applied. Reprime porous areas or areas where primer has dried.
3.3.2
Floor Surfacing
**************************************************************************
NOTE: Specify desired thickness of resinous
flooring. Latex and resinous emulsion matrix
flooring should be installed 6, 10 and 13 mm (1/4,
3/8, and 1/2 inch) thick for light, medium, and
heavy duty traffic. Epoxy and polyester matrix
flooring should be installed 3, 5 and 6 mm (1/8,
3/16, and 1/4 inch) thick for light, medium, and
heavy duty traffic.
Use first bracketed option requiring continuous
floor installation only if structural floor control
joints have been located out of floor area.
**************************************************************************
Apply mixed surfacing material to provide a finish floor surfacing not less
than [_____] mm inch thick. The entire surfacing in any one room or area
shall be [placed in one continuous operation without use of cold joints or
divider strips] [one continuous operation except for placement of divider
strips at structural floor control joints or as indicated]. All surfaces
shall be flush, true to plane and line, and level within 2 mm in one meter
1/4 inch in 10 feet.
3.3.3
Seal Coat
Apply seal coat uniformly covering all surfaces after floor surfacing has
cured and as recommended by the supplier.
3.4
TESTING
**************************************************************************
NOTE: For explosive and ammunition facilities and
other facilities requiring conductive sparkproof
industrial resinous flooring, edit the following
paragraphs. Omit when not required.
**************************************************************************
SECTION 09670
Page 17
Previous Page
