specifications.
If prefinished flooring is used, delete this
paragraph.
**************************************************************************
3.3.1
Sanding
Sand and buff floors to smooth and level surface, free of sanding marks and
in proper condition to receive the finish specified. After final sanding
and buffing, vacuum or tack floors in accordance with finish manufacturer's
recommendations. Wipe off foot marks.
3.3.2
Finishing
After final sanding and buffing have been completed, apply two coats of
finish; use polyurethane coating recommended by flooring manufacturer for
type and specie of wood flooring specified.
When floors are dry, apply two coats of wax, unless otherwise recommended
in writing by manufacturer of flooring. Spread at rate of 0.07 L/10 square
meters one gallon per 1,500 square feet. Within 15 to 30 minutes after wax
application, polish floors with weighted floor brush or electric polisher.
3.4
PROTECTION
After completion of laying [and the finishing and drying] of floors, cover
flooring immediately with nonstaining kraft building paper. Edges of paper
shall be lapped and taped. At project completion and acceptance, carefully
take up and remove the protective paper.
-- End of Section --
SECTION 09645
Page 12
Previous Page
