SECTION 09210 GYPSUM PLASTER

**************************************************************************

USACE / NAVFAC / AFCESA

UFGS-09210 (October 2003)

------------------------------

Preparing Activity: NAVFAC

Superseding

UFGS 09212N (September 2000)

UNIFIED FACILITIES GUIDE SPECIFICATIONS

References are in agreement with UMRL dated 23 June 2005

Revised throughout - changes not indicated by CHG tags

**************************************************************************

SECTION 09210

GYPSUM PLASTER

10/03

**************************************************************************

NOTE: This guide specification covers the

requirements for interior and exterior plaster work.

Comments and suggestions on this guide specification

are welcome and should be directed to the technical

proponent of the specification. A listing of

technical proponents, including their organization

designation and telephone number, is on the Internet.

Recommended changes to a UFGS should be submitted as

a Criteria Change Request (CCR).

Use of electronic communication is encouraged.

Brackets are used in the text to indicate designer

choices or locations where text must be supplied by

the designer.

**************************************************************************

NOTE: Gypsum plaster refers to interior work.

Stucco refers to cement plaster used on the building

exterior. The extent and location of the work to be

accomplished, and the type of plaster required

should be indicated on the project drawings.

**************************************************************************

NOTE: Specification requirements of a one-coat

system are interior applications for Puerto Rico.

The one-coat system is Portland cement plaster with

a sand float finish applied to concrete masonry

units and concrete surfaces.

**************************************************************************

NOTE: This specification is for unrestrained stucco

and plaster systems. The cold-formed metal framing

(Section 05400 COLD-FORMED METAL FRAMING) and

SECTION 09210

Page 3