b.
Adhesively bonded insulated panels shall be nonmetallic faced,
sandwich type, [_____] [tempered hardboard] on exposed face and on
nonexposed face. Apply coating of [epoxy] [polyester] [_____]
followed by application of [inert aggregate] [_____] to exposed
face in the [factory] [field]. [Inert aggregate] [_____] shall be
[natural stone chips] [crushed marble] [_____] [with minimum and
maximum sizes of [_____] and [_____]]. Color of [_____] shall be
[_____].
c.
Nonmetallic panels, [_____] surfaced: [_____] [tempered
hardboard] [_____] board base with applied [factory] [or] [field]
finish of [[_____] resins and decorative natural stone chips]
[_____]. Apply [epoxy] [polyester] coating of [_____] followed by
application of [inert aggregate] [_____] to exposed face in the
[factory] [field]. [Inert aggregate] [_____] shall be [natural
stone chips] [crushed marble] [_____] [with minimum and maximum
sizes of [_____] and [_____]]. Color of [_____] shall be [_____].
2.1.17
Metal Windows
**************************************************************************
NOTE: Insert appropriate Section number and title
in blank below using format per UFC 1-300-02.
**************************************************************************
[Fixed] [Operating] [Fixed and operating]. Comply with requirements of
[_____], [Steel] [Aluminum] Windows [_____] [AAMA 101] [SWI SGSW] as
modified herein. Provide inside glazing with removable metal glazing beads
[except for windows having structural gaskets]. Comply with glass
clearance dimensions and sealant dimensions recommended by glass
manufacturer.
2.1.17.1
Frames
Frames for fixed glazed panels and window units shall be [aluminum]
[bronze] [stainless steel] [steel].
2.1.17.2
Operating Windows
Operating windows shall be [double-hung] [projected] [horizontally pivoted]
[vertically pivoted] [top-hinged inswinging] [horizontal sliding]
[casement] [_____] type. [Operating windows shall be complete with
hardware, weatherstripping, and accessories.] Hardware shall comply with [
AAMA 101] [SWI SGSW] modified as follows:
a.
Metal and finish for hardware shall be [_____].
b.
[_____].
2.1.17.3
Window Construction
Weld or mechanically join and seal corners of frames and ventilators for
water-tight construction. Remove excess metal from welded joints and dress
smooth on exposed and contact surfaces so that no objectionable
discoloration or roughness will be visible after finishing. Apply sealing
compound in interior surfaces of corners and frame intersections.
SECTION 08900
Page 24
Previous Page
