2.1.10.6
Preformed Sealing Compound
Provide nonskinning type conforming to AAMA 800.
Tapes, beads, ribbons or
other shapes as required.
2.1.11
Glass and Glazing
[Materials are specified under Section 08800 GLAZING.] [Conform to ASTM C
1036, except ASTM C 1048 for spandrel glass. All glazing material must be
certified as meeting 16 CFR 1201.]
2.1.11.1
Glass Sizes and Clearances
Sizes indicated are nominal. Verify actual sizes required by measuring
frames. Coordinate dimensions for glass and glass holding members to meet
applicable minimum clearances as recommended by glass manufacturer. Do not
nip to remove flares or to reduce oversized dimensions.
2.1.11.2
Clear Primary Float Glass
Provide Type I, Class I, quality q3, [6 mm1/4 inch thick] [_____].
2.1.11.3
Heat-Absorbing Glass
Clean cut, Type [I] [II], Class [2], style [A] [B], [_____] in color,
thickness [[_____] mm inch] [as indicated].
2.1.11.4
Insulating Glass
Fused glass, banded, or unbanded. Banded type, ASTM E 774, Class [A]
[_____] shall have perimeter banded or sealed, and encased in a nonferrous
metal or stainless steel frame. Unbanded type shall have perimeter sealed
by manufacturer's standard organic sealant. Do not field cut.
2.1.11.5
Spandrel Glass [With Adhered Backing]
ASTM C 1048, kind FT or HS, condition B, Type I, [_____] thickness [[_____]
mm inch] [as indicated].
2.1.11.6
Glass Setting Materials
a.
Sealants and preformed sealing compounds: Shall be as specified
under paragraph entitled "Joint Sealant and Accessories."
b.
Preformed compression gaskets and seals: ASTM C 864, color
[black] [_____]. Gaskets used for [_____] shall have durable
compatible, and colorfast coating.
c.
Preformed lock-strip type gaskets: ASTM C 542, factory formed,
color [black] [_____]. Provide separate filler or locking strips,
approximately 10 Shore "A" Durometer points harder than gasket
body, and insure permanent and continuous pressure of sealing
lips. Grooves and ends shall be square butted or mitered 45
degrees.
d.
Setting blocks, edge blocks, and spacer shims: Fabricate from
neoprene or other materials recommended by glass manufacturer
compatible with compounds, sealants, or gaskets used. Unless
SECTION 08900
Page 21
Previous Page
