WARRANTY -82100007

minimum of 100 mm 4 inches thick, located at each end and at the midpoint

of the door. Store doors in a well-ventilated building so that they will

not be exposed to excessive moisture, heat, dryness, direct sunlight, or

extreme changes of temperature and humidity. [Do not store in a building

under construction until concrete, masonry work, and plaster are dry.]

Replace defective or damaged doors with new ones.

1.4

WARRANTY

**************************************************************************

NOTE: The warranty clause in this guide

specification has been approved by NAVFACENGCOMHQ in

accordance with the requirements of NAVFAC P-68. The

paragraph in this guide specification may be used

without any other HQ approval or request for waiver.

**************************************************************************

Warranty shall warrant doors free of defects as set forth in the door

manufacturer's standard door warranty.

PART 2

PRODUCTS

2.1

DOORS

**************************************************************************

NOTE: It is preferred that door sizes, designs and

thicknesses be indicated on the drawings; if not

indicated, schedule appropriate criteria in

specifications. Refer to WDMA I.S. 1-A and WDMA

I.S. 6 for stock sizes and designs; the use of stock

doors is recommended.

**************************************************************************

NOTE: Include requirements for wood frames, except

for prehung interior wood door units, in Section

06200, "Finish Carpentry." Include requirements for

metal frames for wood doors in Section 08110, "Steel

Doors and Frames." Include requirements for

hardware, other than for sliding and bi-fold doors,

in Section 08710, "Door Hardware."

**************************************************************************

NOTE: Premium or select grade is intended for

natural or stain finish, standard grade is intended

for opaque (paint) finish.

**************************************************************************

Provide doors of the types, sizes, and designs [indicated] [specified].

2.1.1

Stile and Rail Doors

[Premium] [Standard] grade Ponderosa Pine doors or [premium or select]

[standard] stile and rail doors conforming to WDMA I.S. 6. When laminated

panels are furnished, they shall be not less than three ply. Flat panels

shall have a minimum finished panel thickness of 13 mm 1/2 inch. Raised

panels shall have a minimum finished panel thickness of 20 mm 3/4 inch.

SECTION 08210

Page 7