accessories, for damage and unload and store doors upright on platforms in
accessible spaces with a minimum of handling. The storage spaces shall be
dry, adequately ventilated, free from heavy dust and not subject to
combustion products, sources of water or other conditions that could damage
the door. Storage spaces shall have easy access for inspection and
handling of doors.
1.5
EXTRA STOCK
[Deliver an extra stock of markings for glass panels to the Government for
use in future replacement of original markings. The extra stock shall be
of the same designs, colors, and materials as the markings installed on
this project. Furnish markings in original containers or packages in a
quantity not less than [_____] percent of the amount of markings to be
installed.]
PART 2
PRODUCTS
2.1
ALUMINUM SLIDING GLASS DOORS
**************************************************************************
NOTE: Aluminum sliding glass doors (SDG)
designation and type in AAMA 101 establishes a
minimum Performance Class for each door Grade: 15
for residential (R) 20 for commercial (C); and 40
for heavy commercial (HC). Units installed in high
wind zones should be specified in accordance with
the recommendation in AAMA 101.
**************************************************************************
**************************************************************************
NOTE: For minimum cost, use stock designs in
standard sizes where possible. Require only minimum
changes to standard design, and use minimum number
of different sizes. Vinyl safety markings should be
used where appropriate to make personnel aware of
glass. If specific designs and colors are required
for markings, indicate on the drawings; in
monumental installation, a horizontal muntin may be
specified or indicated.
**************************************************************************
Design and construct with sliding panels and fixed panels in the sizes and
arrangements indicated and conforming to AAMA 101 for Type [SGD-R15]
[SGD-C20] [SGD-HC40], [SGD-_____] [except frame shall be equipped with
thermal barrier]. [Mark panels identically and permanently to visibly
interrupt the span of glass. Use markings [of the design and color
indicated] [approximately 2500 square millimeters (mm) 4 square inches] of
opaque, pressure-sensitive vinyl film with precoated adhesive.] Sliding
door glazing shall be set in aluminum frames and roller assemblies of
sufficient strength to withstand lateral live stresses and static load or
weight requirements.
2.1.1
Hardware
**************************************************************************
NOTE: Key-operated cylinders may be incorporated
into a master keying system provided they are: (1)
manufactured by the same manufacturer as the
SECTION 08161
Page 6
Previous Page
