Glass required in laminated casework shall be referenced by type in
accordance with Section 08800 GLAZING. Glass shall be one of the following:
a. Type [A] [_____].
b. [Float] [Patterned] glass: [Clear] [pattern] quality.
c. Safety glass: [Clear] [_____]; [heat strengthened] [fully tempered]
[laminated] [_____]; [_____] mm inches thick minimum.
d. Wire Glass: [Clear] [_____], polished [both sides] [one side];
[square] [diagonal] [_____] mesh woven stainless steel wire of grid
[_____] mm inches size; [_____] mm inches thick.
2.11.2
Grommets
Grommets shall be [plastic] [metal] [rubber] [_____] material for cutouts
with a diameter of [_____] mm inches. Locations shall be as indicated on
the drawings.
2.12
FABRICATION
**************************************************************************
NOTE: Fabrication as described below is for typical
casework cabinetry and restroom vanity construction.
Techniques, methods, and materials would also apply
to other laminated architectural casework
fabrications such as built-in shelving, bookcases,
and cafeteria counters. Where one or more options
are shown, all options are acceptable for either AWI
premium or custom grade unless other wise noted.
The specification should be edited and tailored to
describe the particular casework items being
fabricated.
Shop fabrication and shop assembly of components
should be maximized to the extent possible. Quality
of fabrication and installation are generally
superior when accomplished in a millwork shop
facility as opposed to field work. Field
fabrication and assembly should be limited to those
assemblies and final adjustments necessary to finish
installation of the casework.
**************************************************************************
Fabrication and assembly of components shall be accomplished at the shop
site to the maximum extent possible. Construction and fabrication of
cabinets and their components shall meet or exceed the requirements for AWI
[premium] [custom] grade unless otherwise indicated in this specification.
Cabinet style, in accordance with AWI Qual Stds, Section 400-G
descriptions, shall be [flush overlay] [reveal overlay] [flush inset
without face frame] [flush inset with face frame] [as indicated on the
drawings].
2.12.1
Base and Wall Cabinet Case Body
**************************************************************************
NOTE: Specifier must choose a material from those
listed below for each component or permit Contractor
SECTION 06410A
Page 16
Previous Page
