minimizes the chance of chipped door edges commonly
seen with laminate edged installations.
The most common edge banding is .020 inches in
thickness and 15/16" wide. This edge banding is
available in almost all solid colors and many
patterns and woodgrains to match all major laminate
selections. If matching is desired, recommend
coordination and selection during casework design to
insure availability.
Edge banding is also available in other thicknesses
for more durability, however, color selection is
very limited in these greater thicknesses.
**************************************************************************
Edge banding for casework doors and drawer fronts shall be PVC vinyl and
shall be [0.5 mm 0.020 inch] [3 mm 0.125 inch] [_____] thick. Material
width shall be [23.8 mm 15/16 inches] [as indicated on the drawings]
[_____]. Color and pattern shall [match exposed door and drawer front
laminate pattern and color] [be as indicated on the drawings] [_____].
2.6
VINYL COUNTERTOP EDGE
Where located on the drawings, vinyl edging for countertops shall be a
tee-mould anchor type with a [flat] [radiused] [_____] edge profile.
Finished width shall be [as indicated on the drawings] [_____]. Color
shall be as indicated on [the drawings] [Section 09915 COLOR SCHEDULE]
[_____].
2.7
CABINET HARDWARE
**************************************************************************
NOTE: To insure a minimum standard quality is met,
every attempt should be made to utilize standard
hardware components which can be found in ANSI/BHMA
A156.9. Use the ANSI/BHMA numbering system to
provide an BHMA number for each component which
specifies the product class, base material, type of
product, description, and grade.
Specially designed, custom, or proprietary hardware
should be thoroughly described and defined in this
paragraph.
The basic hardware components listed and described
below are not inclusive. The list should be edited
to modify, delete, or add hardware components as
necessary to provide the specifications required for
each end use and casework function.
**************************************************************************
All hardware shall conform to BHMA A156.9, unless otherwise noted, and
shall consist of the following components:
**************************************************************************
NOTE: Hinge type will depend on cabinet
construction style requiring flush, inset lipped, or
overlay door design, and desired appearance.
SECTION 06410A
Page 13
Previous Page
