1.3.2
Certification of Piston Tool Operator
Manufacturer's certificate attesting that the operators are authorized to
use the low velocity piston tool.
1.3.3
Qualification of Welders
Provide welder qualification procedures, welder qualifications, and
duration of qualification period in accordance with AWS D1.1/D1.1M and AWS
D1.3.
1.3.4
Regulatory Requirements
**************************************************************************
NOTE: For roofing systems with insulation/
underlayment applied directly to deck, include
applicable paragraph/sentence for fire rated and/or
windstorm resistance. Specify roof assemblies that
are in consonance with other roof components
(Supports, deck, adhesives, bitumen, fasteners and
attachments, vapor retarders, insulation, membrane,
and surfacing) so that the roof construction
assembly results in UL or FM fire-resistance and
windstorm resistance classification required by
project criteria.
**************************************************************************
1.3.4.1
Fire Safety
Roof deck shall have been tested as a part of a roof deck construction
assembly of the type used for this project, shall be listed as fire
classified in the UL Bld Mat Dir, or listed as Class I construction in the
FM P7825, and so labeled.
1.3.4.2
Wind Storm Resistance
**************************************************************************
NOTE: Select the appropriate wind uplift pressure
based on wind speeds used by the structural designer
in accordance with UFC 3-310-01, "Load Assumptions
for Buildings".
**************************************************************************
The roof construction assembly shall be capable of withstanding an uplift
pressure of [3] [5] [_____] kPa [60] [90] [_____] pounds per square foot
when tested in accordance with the uplift pressure test described in the FM
DS 1-28 or as described in UL 580 and in general compliance with UFC
3-310-01.
1.3.5
Fabrication Drawings
Show type and location of units, location and sequence of connections,
bearing on supports, methods of anchoring, attachment of accessories,
adjusting plate details, size and location of holes to be cut and
reinforcement to be provided, the manufacturer's erection instructions and
other pertinent details.
SECTION 05310
Page 8
Previous Page
