160 km per hour (100 mph) or more, adjustable
pintle-eye type wire anchors should not be used and
this paragraph should be deleted.
**************************************************************************
Adjustable pintle-eye type wall anchors shall be two pieces rectangular
type double pintle anchors.
2.9.2
Dovetail Anchors
**************************************************************************
NOTE: If no connections of masonry veneer to
concrete members are required, this paragraph should
be deleted.
**************************************************************************
Dovetail slots are specified in Section [03300A CAST-IN-PLACE STRUCTURAL
CONCRETE][03300N CAST-IN-PLACE CONCRETE].
2.10
CONNECTIONS
Screws, bolts and anchors shall be hot-dip galvanized in accordance with
ASTM A 123/A 123M or ASTM A 153/A 153M as appropriate.
2.10.1
**************************************************************************
NOTE: This paragraph should be edited to reflect
the design option selected.
**************************************************************************
Screws, bolts and anchors used in the assembly of the cold-formed steel
framing system shall be [as shown.] [as required by design of the framing
system for the specified loading.] Screw, bolt and anchor sizes shall be
2.10.2
Welding
**************************************************************************
NOTE: The welding of cold-formed steel should be
performed by qualified workmen. The Contractor,
Subcontractor or Fabricator shall provide
verification that welders are qualified in
accordance with AWS D1.3.
**************************************************************************
Welded connections shall be designed and all welding shall be performed in
accordance with AWS D1.3, as modified by AISI SG-971-Spec. Welders shall
be qualified in accordance with AWS D1.3. All welds shall be cleaned and
touched-up with zinc-rich paint.
2.10.3
Veneer Anchor Screws
**************************************************************************
NOTE: This paragraph should be edited to reflect
the design option selected.
**************************************************************************
Screws for attachment of the veneer anchors to the cold-formed steel
SECTION 04810
Page 17