ASTM C 989
(2004) Ground Granulated Blast-Furnace
Slag for Use in Concrete and Mortars
ASTM D 4791
(1999) Flat Particles, Elongated
Particles, or Flat and Elongated Particles
in Coarse Aggregate
NATIONAL INSTITUTE OF STANDARDS AND TECHNOLOGY (NIST)
NIST HB 44
(2004) NIST Handbook 44: Specifications,
Tolerances, and other Technical
Requirements for Weighing and Measuring
Devices
U.S. ARMY CORPS OF ENGINEERS (USACE)
COE CRD-C 100
(1975) Method of Sampling Concrete
Aggregate and Aggregate Sources, and
Selection of Material for Testing
COE CRD-C 104
(1980) Method of Calculation of the
Fineness Modulus of Aggregate
COE CRD-C 114
(1997) Test Method for Soundness of
Aggregates by Freezing and Thawing of
Concrete Specimens
COE CRD-C 130
(2001) Standard Recommended Practice for
Estimating Scratch Hardness of Coarse
Aggregate Particles
COE CRD-C 318
(1979) Federal Specifications for Cloth,
Burlap, Jute (or Kenaf)
COE CRD-C 400
(1963) Requirements for Water for Use in
Mixing or Curing Concrete
COE CRD-C 94
(1966) Specification for Surface Retarders
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
SECTION 03372
Page 7
Previous Page
