b.
WCLIB 17 standard grading rules, [Douglas Fir] [Western Cedars], A
& Btr.
c.
SPIB 1003 grading rules, Southern Pine, C & Btr.
d.
SCMA Spec standard specification, Cypress, C-Select.
e.
RIS Grade Use standard specifications, Redwood, [Clear] [Clear All
Heart].
f.
NHLA Rules rules, [Cypress] [Teak], [B Finish] [Select or Btr.].
2.1.13.1
Moisture Content
Air-dry or kiln-dry lumber. Kiln-dry treated lumber after treatment.
Maximum moisture content of wood products at time of delivery shall be as
per manufacturers standard. If no manufacturer's standard exists, then
moisture content shall be based on requirements for the product, grade and
intended use.
2.1.13.2
Treatment
Wood that is not naturally rot and insect resistant shall be treated with
standard procedures. Creosote, pentachlorophenol, tributyl tin oxide shall
not be used in conformance with ASTM F 1487. Ammonium Copper Quat (ACQ)
shall not be used for surfaces likely to contact the skin of small
children. AWPA C1 and AWPA C9, as applicable, and inspected in accordance
with AWPA M2.
2.1.13.3
Wood Seats and Table Tops
Clear teak, maple, oak, Jarrah, Ipe or other suitable hardwood, not less
than 40 mm 1 5/8 inches thick with rounded edges.
2.1.14
Fiberglass
Fiberglass shall consist of at least 3 laminations of chopped glass fibers
impregnated with polyester resin, with colors and textures molded into all
exposed surfaces so that colors resist fading. Fiberglass shall be
resistant to cleaners, fertilizers, high power spray and salt.
2.2
PRETREATMENT, PRIMING AND PAINTING
**************************************************************************
NOTE: Use manufacturers standard treatment when
painting and finishing is required.
**************************************************************************
Apply pretreatment, primer, and paint in accordance with manufacturer's
printed instructions. [On surfaces concealed in the finished construction
or not accessible for finish painting, apply an additional prime coat to a
minimum dry film thickness of 0.03 mm 1.0 mil. Tint additional prime coat
with a small amount of tinting pigment.]
2.2.1
Nonferrous Metal Surfaces
Protect by plating, anodic, or organic coatings.
SECTION 02870
Page 15
Previous Page
