SECTION 02821N CHAIN LINK FENCES AND GATES

**************************************************************************

USACE / NAVFAC / AFCESA

UFGS-02821N (September 1999)

------------------------------

Preparing Activity: NAVFAC

Replacing without revision

NFGS of same number and date

UNIFIED FACILITIES GUIDE SPECIFICATIONS

References are in agreement with UMRL dated 23 June 2005

**************************************************************************

SECTION 02821N

CHAIN LINK FENCES AND GATES

09/99

**************************************************************************

NOTE: This guide specification covers the

requirements for chain-link fencing and is intended

to be used in specifying chain-link fence for

general-purpose and special-purpose use.

Comments and suggestions on this guide specification

are welcome and should be directed to the technical

proponent of the specification. A listing of

technical proponents, including their organization

designation and telephone number, is on the Internet.

Recommended changes to a UFGS should be submitted as

a Criteria Change Request (CCR).

Use of electronic communication is encouraged.

Brackets are used in the text to indicate designer

choices or locations where text must be supplied by

the designer.

**************************************************************************

NOTE: Certain types of security fence must meet the

requirements of an applicable OPNAVINST. Edit this

specification as needed for the type of fencing

required.

**************************************************************************

NOTE: The following information shall be shown on

the project drawings:

1.

Fence alignment.

2. Posts:

Minimum height to accommodate fabric and

clearance.

3. Post Setting Dimensions: Not less than

indicated in chain link manufacturer's installation

standards. Assure that embedment length in concrete

slabs and walls will be at least 300 mm 12 inches.

SECTION 02821N

Page 3