PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM D 1149
(1999) Rubber Deterioration - Surface
Ozone Cracking in a Chamber
ASTM D 2136
(2002) Coated Fabrics - Low-Temperature
Bend Test
ASTM D 3020
(1989) Polyethylene and Ethylene Copolymer
Plastic Sheeting for Pond, Canal, and
Reservoir Lining
ASTM D 3083
(1989) Flexible Poly(Vinyl Chloride)
Plastic Sheeting for Pond, Canal, and
Reservoir Lining
ASTM D 413
(1998; R 2002e1) Rubber Property -
Adhesion to Flexible Substrate
ASTM D 751
(2000) Coated Fabrics
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
SECTION 02661
Page 4
Previous Page
