equipment at project sites for a total of 16 hours of instruction per
student, in blocks of 4 hours. Maximum of [5] [_____] personnel shall
attend the course. Include hands-on training under constant monitoring of
instructor. Course content shall duplicate the Operator Training I course
as applied to the installed system. Instructor shall determine the level
of the password to be issued to each student before each session. Upon
completion of the course, students shall be proficient in system operation.
Prepare a written report describing the skill level of each student at the
end of the course.
3.4.4
Operator Training III
The third course shall be taught in the field, at the project site, for a
period of 3 training days no later than 6 months after completion of
endurance test. Maximum of [5] [_____] personnel shall attend the course.
Course shall be structured to address specific topics that the students
need to discuss and to answer questions concerning operation of the system.
Upon completion of the course, students shall be proficient in system
operation and shall have no unanswered questions regarding operation of the
installed system.
3.4.5
System Maintenance Training
Course shall be taught at the project site within one month after
completion of endurance test for a period of 2 training days. Maximum of
[_____] personnel shall attend the course. Course shall include but not be
limited to the following:
a.
Physical layout for each piece of hardware
b.
Troubleshooting and diagnostics procedures
c.
Repair instructions
d.
Preventive maintenance procedures and schedule
e.
Calibration procedures
3.5
QUALIFIED SERVICE ORGANIZATION LIST
The qualified service organization list shall include names and telephone
numbers of organizations qualified to service HVAC control systems.
3.6
COMMISSIONING
**************************************************************************
NOTE: If commissioning procedures are required
beyond the scope of those described in Section
15950, "HVAC Testing/Adjusting/Balancing," include
procedures in this paragraph.
**************************************************************************
Commissioning of control systems is specified in the pre-field TAB
engineering report described in Section 15950N HVAC
TESTING/ADJUSTING/BALANCING.
3.7
SCHEDULE
Some metric measurements in this section are based on mathematical
SECTION 15901N
Page 50
Previous Page
