PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AIR MOVEMENT AND CONTROL ASSOCIATION INTERNATIONAL(AMCA)
AMCA 201
(2002) Fans and Systems
AMCA 210
(1999) Laboratory Methods of Testing Fans
for Aerodynamic Performance Rating
AMCA 500-D
(1998) Laboratory Methods of Testing
Dampers for Rating
AMCA 801
(2001) Industrial Process/Power Generation
Fans: Specification Guidelines
AMCA 802
(2002) Industrial Process/Power Generation
Fans: Establishing Performance Using
Laboratory Models
AMCA 99
(1999; R 2003) Standards Handbook
AMERICAN BEARING MANUFACTURERS ASSOCIATION (ABMA)
ABMA 11
(1990; R 1999) Load Ratings and Fatigue
Life for Roller Bearings
ABMA 9
(1990; R 2000) Load Ratings and Fatigue
Life for Ball Bearings
AMERICAN INSTITUTE OF STEEL CONSTRUCTION (AISC)
AISC 335
(1989) Structural Steel Buildings
Allowable Stress Design and Plastic Design
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C50.41
(2000) Polyphase Induction Motors for
Power Generating Stations
ANSI S12.34
(1999) Engineering Methods for the
Determination of Sound Power Levels of
Noise Sources for Essentially Free - Field
Conditions Over a Reflecting Plane (Note:
was ASA77, but that document refers to
SECTION 15864N
Page 7
Previous Page
