a voltage of approximately 500 volts for a direct reading of insulation
3.2.3.4
After completing fire tests and insulation-resistance tests, operate
equipment continuously under varying load conditions to verify functioning
of combustion controls, electrical controls, flame safeguard controls,
safety interlocks, and specified operating sequence. Run each test for a
minimum period of one hour.
3.3
SCHEDULE
Some metric measurements in this section are based on mathematical
conversion of inch-pound measurements, and not on metric measurements
commonly agreed on by the manufacturers or other parties. The inch-pound
and metric measurements shown are as follows:
Products
Inch-Pound
Metric
a.
Motor
Capacity
= 7 1/2 hp
= 5 1/2 kW
= 15 hp
= 11 kW
= 30 hp
= 22 3/8 kW
-- End of Section --
SECTION 15760N
Page 16
Previous Page
