insufficient to preclude freeze-ups. Either
electric immersion heaters or steam or hot water
coils may be used for supplemental heating.
5. Design refrigeration systems for air conditioning
using energy efficiency in compliance with
FEMP/Energy Star requirements specified at
www.eren.doe.gov/femp/procurement. Indicate
efficiency design parameters for equipment on the
drawings.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AIR-CONDITIONING AND REFRIGERATION INSTITUTE (ARI)
ARI 450
(1999) Water-Cooled Refrigerant
Condensers, Remote Type
ARI 460
(2000) Remote Mechanical-Draft Air-Cooled
Refrigerant Condensers
ARI 480
(2001) Refrigerant-Cooled Liquid Coolers,
Remote Type
ARI 520
(1997) Positive Displacement Condensing
Units
ARI 550/590
(2003) Water Chilling Packages Using the
Vapor Compression Cycle
ARI 560
(2000; Addenda 2002) Absorption Water
Chilling and Water Heating Packages
AMERICAN GEAR MANUFACTURERS ASSOCIATION (AGMA)
AGMA 2005
(1996; Rev C) Design Manual for Bevel Gears
AGMA 373.04
(1973) Design for Fine-Pitch Wormgearing
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI S1.13
(1995; R 1999) Methods for the Measurement
SECTION 15601N
Page 6
Previous Page
