curves required in paragraph PUMP TEST [AND CAVITATION TESTS] along with a
set of sample calculations with constants and conversion factors.
[Two][Three][Four] weeks will be required to review this data before the
Contracting Officer will be available to visit the Contractor's laboratory
for witnessing the test. Should the results of the witness test reveal
that the tested pump does not perform in accordance with the requirements
of the specification and the guaranteed values, the Contractor shall make
such changes as are required to make it acceptable before again notifying
the Contracting Officer that the witness tests are ready to be run.
Immediately upon completion of each witness test, copies of all data taken
during the test shall be delivered to the Contracting Officer witnessing
the test. Computations of test results and plotted preliminary curves
shall be furnished to the witness.
2.5.3.8
Test Report
**************************************************************************
NOTE: Delete item "o" if water passage is not
included in the contract.
**************************************************************************
Submit, within 30 days
of receipt of approval of the witness test, to
Government [3] [4] [7]
bound copies of a report covering completely test
setup and performance[
and cavitation] tests. Each test report shall
include, as a minimum,
the following:
a.
Statement of the purpose of test, name of project, contract
number, and design conditions should be given. Where guaranteed
values differ from specified values, they also should be given.
b.
A resume of preliminary studies, if such studies were made.
c.
Description of test pump and motor, including serial numbers, if
available. Information required under "b" may be included here.
d.
Description of test procedure used, including dates, test
personnel, any retest events, and witness test data.
e.
List of all test instruments with model numbers and serial numbers.
f.
Sample computations (complete).
g.
A discussion of test results.
h.
Conclusions.
i.
Photographic evidence in the form of either 24 color photographs
of test equipment, test setup and representative test segments,
and a VHS videotape, at least 30 minutes in length, covering the
same information as photographs. All photographic evidence should
be labeled with Contract number, location, date/time, and test
activity. Videotape shall be voice annotated with the same
information.
j.
Copies of instrument calibration.
k.
Copies of all recorded test data.
l.
Curves required by paragraph TESTS RESULTS.
SECTION 15131A
Page 47
Previous Page
