2. Locations of all anodes, rectifiers, power
sources and test stations.
3.
Locations of all insulating flanges and unions.
4. Installation details of anodes, rectifiers and
bond cables.
5.
Locations of nearby cathodic protection systems.
6. Electrical single-line diagrams, elevations,
limiting dimensions, and equipment ratings which are
not covered in the specification.
7. Remote indicating or control requirements.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B18.2.1
(1996; Errata 2003) Square and Hex Bolts
and Screws Inch Series
ANSI C119.1
(2002) Sealed Insulated Underground
Connector Systems Rated 600 Volts
ASME INTERNATIONAL (ASME)
ASME B1.1
(2001; R 2003) Unified Inch Screw Threads
(UN and UNR Thread Form)
ASME B1.20.1
(1983; R 2001) Pipe Threads, General
Purpose, Inch
ASME B16.21
(1992) Nonmetallic Flat Gaskets for Pipe
Flanges
ASME B16.25
(1997) Buttwelding Ends
ASME B16.39
(1998) Malleable Iron Threaded Pipe Unions
ASME B16.5
(2003) Pipe Flanges and Flanged Fittings
SECTION 13111N
Page 5
Previous Page
