SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM A 167
(2004) Stainless and Heat-Resisting
Chromium-Nickel Steel Plate, Sheet, and
Strip
ASTM A 568/A 568M
(2004) Steel, Sheet, Carbon, and
High-Strength, Low-Alloy, Hot-Rolled and
Cold-Rolled, General Requirements for
ASTM B 221
(2004a) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes
ASTM B 221M
(2004) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes (Metric)
ASTM D 2665
(2004a) Poly(Vinyl Chloride) (PVC) Plastic
Drain, Waste, and Vent Pipe and Fittings
1.2
RELATED REQUIREMENTS
Conform to Section[s] 11700 GENERAL REQUIREMENTS FOR MEDICAL AND DENTAL
EQUIPMENT[,] [.]" [15050N BASIC MECHANICAL MATERIALS AND METHODS][,][.]"
[and] [16050N BASIC ELECTRICAL MATERIALS AND METHODS.] Provide final
utility connections and utility service to equipment.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
SECTION 11475
Page 4
Previous Page
