supports, braces, fasteners, and connections necessary for completion of
the work.
2.7
LABELING
Forced entry resistant components shall be plainly and permanently labeled
as to the applicable forced entry test standard and level within the test
standard under which the component was tested and approved. Label shall be
visible only from the protected side after component installation and shall
include the following information: (1) manufacturer's name or identifying
symbol; (2) model number, control number, or equivalent; (3) date of
manufacture with the week, month or quarter, and year (this may be
abbreviated or be in a traceable code such as the lot number); (4) correct
mounting position (by removable label); and (5) forced entry resistant
rating by indicating the test standard, level within the test standard (if
any), and minutes of attack time withstood (if variable in the standard).
2.8
FABRICATION
Components shall be constructed, assembled, welded, and equipped with all
hardware and accessories required to complete the assembly in the shop of a
competent fabricator.
2.9
FASTENERS
Fasteners exposed to view shall match in color and finish and shall
harmonize with the material to which fasteners are applied. Holes for
bolts and screws shall be drilled or neatly punched. Poor matching of
holes shall be cause for rejection of the work. Fasteners shall be
concealed where practicable. Unless otherwise specified, fasteners shall
conform to Section 05500A MISCELLANEOUS METAL.
2.10
SHOP/FACTORY FINISHING
Unless otherwise specified, all factory or manufactured components shall be
shop finished as indicated below.
2.10.1
Ferrous Metal
Surfaces of ferrous metal, except galvanized and stainless steel surfaces,
shall be cleaned and factory primed for painting. Finish painting shall be
in accordance with Section 09900 PAINTS AND COATINGS. Prior to shop
painting, surfaces shall be cleaned with solvents to remove grease and oil
and with power wire-brushing or sandblasting to remove loose rust, loose
mill scale, and other foreign substances. Surfaces of items to be embedded
in concrete shall not be shop painted.
2.10.2
Galvanizing
Items specified to be galvanized shall be hot-dip processed after
fabrication. Galvanizing shall be in accordance with ASTM A 123/A 123M or
ASTM A 653/A 653M.
2.10.3
Aluminum
Unless otherwise specified, aluminum items shall be standard mill finish.
When anodic coatings are specified, coatings shall conform to AA STFA-601711,
with treatment to a coating thickness not less than that specified for
protective and decorative type finish in AA DAF-45. Items to be anodized
SECTION 11025
Page 26
Previous Page
