surface temperatures each day.
e. Use a non-contact thermometer to locate temperature extremes, then
verify with contact thermometers.
Document all equipment used in inspections and testing, including
manufacturer, model number, serial number, last calibration date and future
calibration date, and results of on-site calibration performed.
3.11.2.2
Daily Inspection Reports
Submit one copy of daily inspection report completed each day when
performing work under this Section, to the Contracting Officer. Use ASTM D
3276 Appendix X1 Inspection Checklist to monitor daily activity and prepare
Daily Inspection Report. Use of forms containing entry blocks for all
required data is encouraged. The data may be in any format, but must be
legible and presented so that it can be easily interpreted. Note all
non-compliance issues, and all issues that were reported for rework in
accordance with QC procedures of Section 01450N DESIGN AND CONSTRUCTION
QUALITY CONTROL. Submit report within 24 hours of date recorded on the
report.
3.11.2.3
Inspection Logbook
A continuous record of all activity related to this Section shall be
maintained in an Inspection Logbook on a daily basis. The logbook shall be
hard or spiral bound with consecutively numbered pages, and shall be used
to record all information provided in the Daily Inspection Reports, as well
as other pertinent observations and information. The Coating Inspector's
Logbook that is sold by NACE is satisfactory. Submit the original
Inspection Logbook to the Contracting Officer upon completion of the
project and prior to final payment. The contracting Officer will forward
the Logbook to LANTNAVFACENGCOM Code 1613G, to be reviewed and filed for
warranty information.
3.11.3
Inspection Equipment
All equipment shall be in good condition, operational within its design
range, and calibrated as required by the specified standard for use of each
device.
3.11.3.1
Black Light
Use a black light having a 365 nanometer intensity of 4,000 microwatts per
square centimeter minimum at 380 mm 15 inches. The Spectroline BIB-150P
from Spectronics Corporation satisfies this requirement.
3.11.4
Hold Points for Quality Control Inspections
Provide appropriate QC inspections at the following hold-points:
Step
Action
Prior to preparation of
Safety inspection
tank(s) for cleaning
and repair
After cleaning of tank(s)
1. Safety inspection, removal of dirt, trash,
and prior to abrasive
blasting
SECTION 09973
Page 31