9. If different levels of Impact Resistance are
specified, indicate locations where each is required.
10. If different thicknesses of insulation board are
to be used for architectural details, indicate the
locations and thicknesses where required. Provide
details which show that additional thicknesses are
achieved by adding insulation board on top of the
continuous underlaying insulation board.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM B 117
(2002) Operating Salt Spray (Fog) Apparatus
ASTM C 1177/C 1177M
(2004e1) Glass Mat Gypsum Substrate for
Use as Sheathing
ASTM C 1186
(2002)
Flat Non-Asbestos Fiber Cement
Sheets
ASTM C 150
(2004a) Portland Cement
ASTM C 473
(2003) Physical Testing of Gypsum Panel
Products
ASTM C 578
(2004) Rigid, Cellular Polystyrene Thermal
Insulation
ASTM C 67
(2003a) Sampling and Testing Brick and
Structural Clay Tile
ASTM C 847
(1995; R 2000) Metal Lath
ASTM C 920
(2002) Elastomeric Joint Sealants
ASTM D 2247
(2002) Testing Water Resistance of
Coatings in 100% Relative Humidity
ASTM D 3273
(2000) Resistance to Growth of Mold on the
Surface of Interior Coatings in an
SECTION 07240
Page 7
Previous Page
