2. Location and extent of cracked concrete or saw
kerfs to be filled with epoxy mortar;
3. Location of dowels to be installed and cracks to
be repaired with non-pressure grout; and
4. Location and sizes of cracks to be filled by
pressure grouting.
**************************************************************************
**************************************************************************
NOTE: This guide specification is intended to be
used in conjunction with other guide specifications
for cement-based concrete materials. Normally, the
applicable formwork, joint construction, reinforcing
and structural concrete sections should be included.
For smaller projects, the specification section
03307 CONCRETE FOR MINOR STRUCTURES should be
included. Determination of appropriate guide
specifications should be made in accordance with EM
1110-2-2000, Chapter 5. Where only small amounts of
cement-based concrete are involved, the applicable
portions of the appropriate guide specifications may
be incorporated into this section. The following
guide specifications are referenced in this
specification:
01270A MEASUREMENT AND PAYMENT
01572 CONSTRUCTION AND DEMOLITION WASTE
MANAGEMENT
01355A ENVIRONMENTAL PROTECTION
02760A FIELD MOLDED SEALANTS FOR SEALING JOINTS
IN RIGID PAVEMENTS
03101A FORMWORK FOR CONCRETE
03151A EXPANSION, CONTRACTION AND CONSTRUCTION
JOINTS IN CONCRETE FOR CIVIL WORKS
03201 STEEL BARS AND WELDED WIRE FABRIC FOR
CONCRETE REINFORCEMENT FOR CIVIL WORKS
03300A CAST-IN-PLACE STRUCTURAL CONCRETE
03301A CAST-IN-PLACE STRUCTURAL CONCRETE FOR
CIVIL WORKS
03307 CONCRETE FOR MINOR STRUCTURES
03371 SHOTCRETE
03372 PREPLACED-AGGREGATE CONCRETE
03415A PRECAST-PRESTRESSED CONCRETE
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
SECTION 03931
Page 8
Previous Page
