Concrete
ASTM C 33
(2003) Concrete Aggregates
ASTM C 494
(1992) Chemical Admixtures for Concrete
ASTM C 59/C 59M5
(2000; Rev A) Blended Hydraulic Cements
ASTM C 59/C 59M5M
(1997) Blended Hydraulic Cements (Metric)
ASTM C 618
(2003) Coal Fly Ash and Raw or Calcined
Natural Pozzolan for Use as a Mineral
Admixture in Concrete
ASTM C 989
(2004) Ground Granulated Blast-Furnace
Slag for Use in Concrete and Mortars
PRECAST/PRESTRESSED CONCRETE INSTITUTE (PCI)
PCI MNL-116
(1999) Quality Control for Plants and
Production of Structural Precast Concrete
Products
PCI MNL-120
(1999) Design Handbook - Precast and
Prestressed Concrete
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
SECTION 02588
Page 5
Previous Page
