for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-03 Product Data
Resilient, foam filled marine fenders
Include dimensions, material specifications, and method of
manufacture.
SD-05 Design Data
Resilient, foam filled marine fenders
Submit calculations, including computer analysis and other
design data.
SD-06 Test Reports
Fender compression test
Fender cyclic-compression test
Fender sustained-load test
Fender pull-through test
Elastomeric skin thickness test
Submit copies of reports of tests specified herein. The tests
shall have been performed within three years of submittal of the
reports for approval. Also, submit reports for tests specified in
referenced documents which are applicable to the particular
material furnished for use.
1.4
QUALITY ASSURANCE
1.4.1
Elastomer Skin
The elastomer skin of the fender shall be free from cracks, burrs, warpage,
checks, chipped or blistered surfaces, and shall have a smooth surface.
1.4.2
Steel Fabrication
The steel used in fabrication shall be free from kinks, sharp bends, and
other conditions which would be detrimental to the finished product.
Manufacturing processes shall not reduce the strength of the steel to a
value less than intended by the design. Manufacturing processes shall be
done neatly and accurately. Make bends by controlled means to insure
uniformity of size and shape.
SECTION 02396
Page 6
Previous Page
