contract because the names of the Contractors must
be give on the NOI.
(2) After construction is completed, a Notice of
Termination (NOT) must be sent to the state office
or Regional USEPA Regional Office.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM D 4439
(2004) Geosynthetics
ASTM D 4491
(1999a) Water Permeability of Geotextiles
by Permittivity
ASTM D 4533
(1991; R 1996) Trapezoid Tearing Strength
of Geotextiles
ASTM D 4632
(1991; R 2003) Grab Breaking Load and
Elongation of Geotextiles
ASTM D 4751
(1999a) Determining Apparent Opening Size
of a Geotextile
ASTM D 4873
(2002) Identification, Storage, and
Handling of Geosynthetic Rolls and Samples
1.2
GENERAL
The Contractor shall implement the storm water pollution prevention
measures specified in this section in a manner which will meet the
requirements of Section 01355A ENVIRONMENTAL PROTECTION, and the
requirements of the National Pollution Discharge Elimination System (NPDES)
permit attached to that Section.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
SECTION 01356A
Page 4
Previous Page
