2. Show single-line system riser diagram. Each
device on the riser should be provided with a device
number indicating building number. Indicate
connection of equipment by circuit runs, or conduit
runs.
**************************************************************************
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C135.30
(1988) Zinc-Coated Ferrous Ground Rods for
Overhead or Underground Line Construction
ELECTRONIC INDUSTRIES ALLIANCE (EIA)
EIA ANSI/EIA/TIA-570
(1991) Residential and Light Commercial
Telecommunications Wiring Standard
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS (IEEE)
IEEE C62.41
(1991; R 1995) Recommended Practice for
Surge Voltages in Low-Voltage AC Power
Circuits
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
NFPA 72
(2002) National Fire Alarm Code
UNDERWRITERS LABORATORIES (UL)
UL 1242
(2000; Rev thru May 2003) Electrical
Intermediate Metal Conduit -- Steel
UL 467
(2004) Grounding and Bonding Equipment
UL 6
(2000; Rev thru May 2003) Rigid Metal
Conduit
UL 797
(2004) Electrical Metallic Tubing -- Steel
1.2
SUBMITTALS
**************************************************************************
SECTION 13853A
Page 4