PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI A135.4
(1995) Basic Hardboard
ANSI A208.1
(1999) Particleboard
ASTM INTERNATIONAL (ASTM)
ASTM A 366/A 366M
(1997e1) Commercial Steel, Sheet,
Carbon,(0.15 Maximum Percent Cold-Rolled
BUILDERS HARDWARE MANUFACTURERS ASSOCIATION (BHMA)
BHMA A156.9
(2003) Cabinet Hardware
HARDWOOD PLYWOOD AND VENEER ASSOCIATION (HPVA)
HPVA HP-1
(2000) American National Standard for
Hardwood and Decorative Plywood
KITCHEN CABINET MANUFACTURERS ASSOCIATION (KCMA)
KCMA A161.1
(2000) Performance & Construction
Standards for Kitchen and Vanity Cabinets
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA LD 3
(2000) High-Pressure Decorative Laminates
NEMA LD 3.1
(1995) Performance, Application,
Fabrication, and Installation of
High-Pressure Decorative Laminates
U.S. DEPARTMENT OF COMMERCE (DOC)
PS1
(1995) Construction and Industrial Plywood
(APA V995)
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
SECTION 12352N
Page 4