material.
2.8
SHOP PRIMED FINISH
After fabrication, clean surfaces of windows, fins, mullions, cover plates
[and screen frames], provide a hot-dip galvanized, phosphate-treated and
shop primed finish. The methods of cleaning, chemical treating,
galvanizing, and painting shall conform to SWI SGSW. Windows shall receive
finish paint coats as specified in Section 09900 PAINTS AND COATINGS.
PART 3
EXECUTION
3.1
INSTALLATION
Install windows in accordance with the manufacturer's printed instructions
and details, except as specified otherwise in this section. Build in
windows as the work progresses. Set windows at indicated elevation,
location, and reveal. Set plumb, square, level, and in alignment. Brace,
strut, and stay to prevent distortion and misalignment.
3.2
Place anchorage as wall construction progresses. Build in anchors or bolt
anchors and fastenings to the jambs of openings and weld securely to the
windows or frames and to the adjoining construction. Space anchors not
more than 400 mm 16 inches apart on jambs, and install a minimum of four
anchors on each side of each opening. Anchors and fastenings shall have
sufficient strength to hold the member firmly in position.
3.3
SEALANTS
Section 07920 JOINT SEALANTS.
3.4
CLEANING
Clean metal surfaces of windows, inside and outside, of mortar, plaster,
paint, and other foreign matter to present a neat appearance and to prevent
fouling of weathering surfaces. Clean and touch-up abraded surfaces of
steel windows. Replace stained, discolored, or abraded windows that cannot
be restored to their original condition with new windows.
-- End of Section --
SECTION 11191
Page 9