2.1.3
Binder
**************************************************************************
NOTE: Delete unsuitable matrix or matrices in
accordance with the following:
Do not use latex or resin emulsion matrices where
maximum resistance to solvents, strong acid or
alkaline solutions is required; where high stain
resistance is required; where maximum resistance to
compressive loads and indentation are required; or
where colored quartz decorative aggregate is
specified.
Do not use epoxy matrix where resistance to strong
oxidizing acid solutions is required; where maximum
fire resistance is required; where subject to
prolonged temperatures in excess of 54 degrees C
(130 degrees F); where frequently exposed to steam
or boiling liquids; where white or light colored
quartz decorative aggregates are specified or where
substrate cannot be thoroughly dried.
Do not use polyester matrix where resistance to
strong alkaline solutions is required; where maximum
fire resistance is required; where maximum slip
occupied during installation; or where food stuffs
will be stored within building during installation.
**************************************************************************
Binder shall be [synthetic rubber latex or resin emulsion] [thermo-setting
epoxy] [or] [medium reactive nonthixotropic modified polyester].
2.1.4
Fillers
Fillers, if required, shall be inert silica, quartz or other hard aggregate
material as recommended by the flooring manufacturer. Fillers shall be
furnished in the quantity necessary to impart the required color and
physical characteristics. The filler shall contain sufficient fines to
provide an even-textured, nonslip type of surface on the finished topping.
2.1.5
Top Coating
**************************************************************************
NOTE: Specify clear top coat for decorative
aggregate flooring. Top coatings are available in
light grey, dark grey, red, blue, tan, brown, dark
green, and light green for industrial resinous
floors. Conductive resinous floorings are dark grey
to black and should be specified with conductive
clear top coats only.
**************************************************************************
Furnish [clear] [[_____] color] coating of type recommended by the
manufacturer.
SECTION 09670
Page 9