3.2.3
Tile Installation
Install and grout tile with water cleanable tilesetting and grouting epoxy
in accordance with ANSI A108.1.
3.3
CLEANING
After grout has hardened, scrub and wash tile surfaces with steam or hot
water to melt wax coating and remove excess grout. Remove remnants of
grout with wide-bladed paint scraper or other tool that will not damage
tile. Rinse tile with clean warm water applied with a flat sponge. Remove
excess water from floor, and leave floor dry when work is completed.
Remove tile from which surface grout cannot be removed without damage to
tile. Remove damaged tile and provide new tile.
3.4
PROTECTION
Cover finished tile floors with clean building paper before permitting foot
traffic on them. Place board walkways on floors that are to be
continuously used as passageways by workmen.
-- End of Section --
SECTION 09330
Page 9