Areas of Hot-Dipped Galvanized Coatings
ASTM B 177
(2001) Engineering Chromium Electroplating
ASTM B 766
(1986; R 2003) Electrodeposited Coatings
of Cadmium
ASTM D 962
(1981; R 2003) Aluminum Powder and Paste
ASTM E 165
(2002) Liquid Penetrant Examination
ASTM E 446
(1998; R 2004e1) Radiographs for Steel
Castings Up to 2 In. (51mm) in Thickness
ASTM E 709
(2001) Magnetic Particle Examination
ASTM E 94
(2004) Radiographic Examination
1.2
UNIT PRICES
**************************************************************************
NOTE: If Section 01270A MEASUREMENT AND PAYMENT is
paragraph title (UNIT PRICES) should be deleted from
this section and the remaining appropriately edited
subparagraphs below should be inserted into Section
01270A.
**************************************************************************
1.2.1
Metalwork Fabrication and Machine Work
1.2.1.1
Payment
[Payment will be made for costs associated with metalwork fabrication and
machine work not specifically provided for elsewhere, which includes costs
for materials, fabricating work, shop and field painting, galvanizing or
other metallic coatings and the installation of metal items shown or
required by these specifications unless otherwise specified. Where payment
is based on scale weights, no payment will be made for material in excess
of a variation from the net weight calculated from the dimensions shown on
the approved detail drawings of 4 percent for fabricated shapes, bars and
plates and 5 percent for castings and forgings. Except where specifically
indicated or specified, no separate payment will be made for bolts, nuts,
pins, washers, studs and strap hangers and the cost of such items shall be
included in the unit prices of items on which they are used.] [No separate
payment will be made for the inspection of welds listed in Section 05055
METALWORK FABRICATION, MACHINE WORK, MISCELLANEOUS PROVISIONS, paragraph
NONDESTRUCTIVE EXAMINATION.]
1.2.1.2
Measurement
[Metalwork fabrication and machine work for which payment is not otherwise
specifically provided in these specifications, will be measured for payment
based upon computed weights per fabricated piece, assembly or cast piece
for the various metals as classified on the approved detail drawings except
as indicated below. Computed weights shall be indicated on the detail
constitute acceptance of the computed weights shown thereon. When
SECTION 05055A
Page 5